Gutter problems · Portland & Beaverton

Clogged downspout

Short answer

If rain spills over the gutter right above a downspout while little or nothing comes out at the bottom, the downspout is plugged. Most plugs sit at the top opening or in an elbow and can be cleared. If water wells up out of the pipe at ground level, the blockage is in the underground drain, which is a different job.

Two photos of the same gutter run beside a shingle roof. Left, before: the gutter is lined with needles and debris. Right, after: the gutter is cleared.
A gutter lined with needles. Needles and debris had built up along this gutter beside the roof. The after photo shows the trough clear and its outlet visible again.

What to look for

How to tell a downspout is clogged.

A downspout is a narrow pipe with two or three bends in it, and everything the gutter collects has to pass through. It takes very little to stop one: a handful of fir needles matted over the opening is enough.

You do not need to see inside. The pipe tells you from the outside.

  1. Overflow in one place.In steady rain, water pours over the gutter directly above the downspout while the rest of the gutter behaves.
  2. Nothing at the bottom.A working downspout runs a strong stream in steady rain. A trickle, or nothing, means a blockage above.
  3. Water from the joints.Water dribbling or spraying from the seams between sections means the pipe is full and backing up.
  4. A dull sound.Tap the downspout with your knuckles. An empty pipe rings hollow. A packed section sounds dull.
  5. Water at the ground.If the downspout runs into a pipe in the ground and water wells up around it, the blockage is below ground.

Four places

Where clogs form.

From the top down. The higher the clog, the more likely it needs a ladder.

  • The opening at the top

    Why there A mat of needles and leaves settles over the hole in the gutter floor. If there is a strainer in the opening, the strainer is often what is matted.

    How it is cleared Lifted out by hand during a gutter cleaning. This one is ladder work.

  • The elbows under the eave

    Why there Most downspouts jog back to the wall through two bends. Twigs, needles, moss clumps and shingle grit wedge there. So do balls and nests.

    How it is cleared Flushed out from below with a hose, or the elbow is taken off. Often reachable only from a ladder.

  • The bottom elbow or extension

    Why there Debris that makes it all the way down packs into the last bend, or into an extension that has been flattened or stepped on.

    How it is cleared The easy one. Take the bottom piece off, clear it and refit it.

  • Below ground

    Why there Silt, roots or a broken pipe in the buried drain line. Water rises in the standpipe and spills at ground level.

    How it is cleared Not a gutter cleaning job. A drain cleaning service or plumber clears and repairs buried lines.

Two kinds of downspout

Above ground or below?

Portland-area downspouts end one of two ways. Some stop above the ground and empty onto a splash block or an extension that carries the water into the yard. Portland ran a Downspout Disconnection Program, so plenty of older homes in the city are set up this way. Others run into a standpipe, the pipe that sticks up out of the ground, and on through a buried drain line.

The difference decides who can fix a blockage. Gutter cleaning deals with the gutter and the downspout you can see. A buried line is drain work.

What the City of Portland says

For downspouts that end at the surface: water should drain at least 2 feet from crawl spaces, porch steps, garages and walkways, at least 6 feet from a basement, and at least 5 feet from the property line. Use a splash block, and do not remove or redirect extensions.

For downspouts that connect to an underground pipe: inspect the standpipe regularly for clogs, and check that it is not loose or cracked.

And either way: do not reconnect a disconnected downspout.

Source: City of Portland Environmental Services (opens in a new tab)

Step by step

Clearing it from the ground.

  1. Find it in the rain, fix it in the dry.Steady rain shows you which downspout is blocked. Do the clearing when the ground and the pipe are dry.
  2. Take off the bottom piece.The extension or bottom elbow is usually held by two short screws, or just pushed on. Wear gloves: the cut edges are sharp. Clear it out.
  3. Tap your way up.Knock on the pipe from the bottom upward and listen for where hollow turns to dull. That is the plug.
  4. Flush upward with a garden hose.Feed the hose up from the bottom as far as it will go and turn it on full. Stand to one side: a plug lets go all at once, with a rush of dirty water.
  5. Try a hand snake.A small drain snake fed up from the bottom breaks up a stubborn plug. Go gently. Downspout metal is thin and dents easily.
  6. Put it back properly.Each section should fit inside the one below it, so water cannot escape at the joint. Tighten the screws and point the extension away from the house.
  7. If it enters a standpipe.The City’s tip for a clog you cannot reach by hand is a high-pressure nozzle on a garden hose, aimed down the standpipe to loosen debris. If water comes straight back up, stop.

From the ground

  • Clear the bottom elbow and extension by hand.
  • Flush from the bottom with a garden hose.
  • Refit every section and screw you took off.
  • Leave a temporary extension on, pointed away from the house, while a buried line waits for repair.

Do not

  • Pour drain cleaner into a downspout. It does nothing to leaves, and the City of Portland does not allow cleaning chemicals in the stormwater system.
  • Keep running water into a pipe that is backing up at the ground. It ends up at your foundation.
  • Take apart the upper sections from a ladder on your own.
  • Reconnect a disconnected downspout to the old standpipe.

If the clog is at the top

The opening and the upper elbows are reached from a ladder at the roof edge. Falls from ladders are the serious risk in this job, not the cleaning. OSHA’s ladder guidance (opens in a new tab) applies at home too: set the ladder on stable, level ground, look for overhead power lines before you move it, keep three points of contact, face the ladder and keep your body between the side rails. Move the ladder instead of reaching.

Know the limit

When to call.

A plug at the bottom is a fair job for a homeowner. Higher up, it is a ladder job at the roof edge, and usually the gutter above needs cleaning as well: whatever blocked the downspout came out of the gutter.

  • The clog is at the top. The opening or the upper elbows cannot be cleared from the ground.
  • The downspout is on an upper story. Or it empties onto a lower roof.
  • It clogs again within weeks. The gutter above is full and feeding it.
  • Water backs up at ground level. The buried line is blocked. Call a drain cleaning service or a plumber.
  • Sections are crushed, split or loose. That is a repair or replacement, not a cleaning.
  • Water is reaching the basement. Do not wait for a dry day.

The service

What a Clear Summit visit covers.

The visit

Gutter cleaning with downspouts flushed

  • DownspoutsAbove-ground downspouts flushed with water to check that they drain.
  • TroughsCleared of leaves, needles and debris, which is where the plug came from.
  • Why flushFlushing checks that the downspouts drain, not just that the troughs look clear.
  • BuildingsThe house, plus any other building named in your quote.

Know the limits

Not part of cleaning

  • Underground drainsA blocked drain line below ground is separate from the above-ground downspouts that gutter cleaning covers.
  • RepairsLeaking seams, loose sections or damaged gutters and downspouts are separate from cleaning.
  • If it still backs upTell the office what you are seeing.

When you ask for a quote

What to tell the office

  • Which downspoutFront or back, and which corner.
  • What it doesOverflows above, leaks at the joints, or backs up at the ground.
  • How it endsOnto the ground, or into a pipe below ground.
  • Guards or coversWhether the gutters have them.

Quotes are free. A request is not a booking: the office confirms the areas, access and price, and the work is scheduled once you approve. Read the gutter cleaning page

Prevention

Keeping downspouts clear.

Almost every downspout clog starts as gutter debris. Keep the gutter clean and the downspout mostly looks after itself.

  • Clean the gutters first. See gutters overflowing in the rain for how often and when.
  • Check the elbows. The City of Portland’s advice is to check and clear elbows and bends in the downspouts to prevent clogging.
  • Think twice about strainers. A strainer in the opening keeps debris out of the pipe, but the strainer itself mats over. It moves the clog to where you need a ladder to reach it.
  • Keep the outlet end clear. Leaves, bark mulch and soil pile up at the end of an extension and dam it.
  • Look after the first fall storm. That is when a season of needles arrives at once.
  • Cut back overhanging branches. Less falls on the roof, so less reaches the pipe.

Questions people ask

How do I know if the clog is in the downspout or underground?

Watch where the water comes out. If the gutter overflows above and the downspout stays dry at the bottom, the plug is in the downspout. If water wells up around the pipe at ground level, the buried drain line is blocked.

Can I unclog a downspout without a ladder?

Often, yes. Take off the bottom elbow or extension, clear it, and flush upward with a garden hose from the bottom. A plug at the very top, in the gutter opening, needs a ladder.

Can a clogged downspout wait until spring?

It should not. Every storm will overflow the gutter at that corner and put the water beside the foundation. Clear Summit’s advice is to take care of overflow right away.

Does gutter cleaning include the downspouts?

With Clear Summit, yes: above-ground downspouts are flushed with water to check that they drain. A blockage in an underground drain line is separate.

Who clears an underground downspout drain?

A drain cleaning service or a plumber. Buried lines can be blocked by silt or roots, or be broken, and need drain equipment to clear or repair.

Why is water leaking from the downspout seams?

Usually because the pipe is blocked below that point and has filled up. It can also mean a section was put back the wrong way, so that it no longer fits inside the piece below it.

Sources

The safety and how-to points on this page come from these documents. Links checked November 17, 2026. What Clear Summit does on a visit is described from our own service pages.

Downspout not draining?

Tell us which downspout, and what you see when it rains. Quotes are free.

Call Get a free quote