Driveways, walkways, patios & decks
Slippery moss or algae on a driveway, patio or deck
Short answer
The slick is a film of algae, with moss in the joints and shaded corners. It is most dangerous when wet. A stiff broom takes off enough to make a path safer today. Cleaning it properly depends on the surface: concrete takes pressure, while wood, pavers and asphalt are easily damaged by it.

What is happening
Why it gets slippery.
Two different things grow on the ground around a Northwest home. Algae is the thin green or dark film. You barely see it dry, and it turns to grease the moment it rains. Moss is the soft green growth in joints, cracks and corners. It holds water like a sponge and keeps the surface around it wet.
Both need damp and shade, and from October to May a north-facing walk or a deck under trees gets months of both. Fallen leaves and needles make it worse: they hold moisture against the surface and break down into food for the next layer.
Clear Summit’s view is simple: walking areas that are not maintained can be a real fall hazard.
- Shaded paths and steps on the north side of the house, or under trees.
- Wood decks especially under planters, mats and furniture, where the boards never dry.
- Where a downspout empties across a walk or patio.
- Paver and brick joints which hold soil and water.
- Low spots where water stands after rain.
A stopgap
Make it safer today.
If someone could slip there tonight, do not wait for a proper cleaning. These steps need a broom and a hose.
They are a stopgap. The film grows back from what is left in the pores of the surface, which is why it then needs cleaning properly.
- Keep people off the worst of it.Block the slick stretch or mark it, and use another route while it is wet.
- Sweep it clear.Take off the leaves, needles and loose moss. They hide the slick and keep it wet.
- Scrub with a stiff broom and water.Hard, short strokes on wet concrete or stone lift a surprising amount of the film. On wood, use a softer deck brush and go with the grain.
- Rinse it away from the path.Push the rinse water onto the lawn or a bed, not down to the street.
- Mind the steps.Steps and slopes are where falls hurt most. Do those first.
Each one is different
Cleaning, surface by surface.
The method that is right for a concrete driveway will ruin a cedar deck. Match the cleaning to what you are standing on.
Concrete driveways and walks
How it takes cleaning The most forgiving surface. A stiff brush and cleaner work, and so does pressure washing.
What to watch for A nozzle held too close or too narrow cuts visible stripes and exposes the stone in the concrete. Keep the wand moving and at a distance.
Pavers and brick
How it takes cleaning Clean up well, as the brick steps further down this page show.
What to watch for Pressure blasts the sand out of the joints, and then the pavers shift. Go gently across the joints and expect to re-sand them.
Asphalt driveways
How it takes cleaning Softer than concrete.
What to watch for High pressure loosens the stone from the surface. Use a brush and a hose, or low pressure only.
Wood decks
How it takes cleaning Wood fibers are easily torn. The USDA Forest Products Laboratory warns that aggressive scrubbing with a caustic cleaner or power washing can remove wood from the surface, particularly on softer wood such as western redcedar.
What to watch for Use a deck cleaner and a soft brush, working along the boards, then rinse. Let the deck dry fully before any finish goes on.
Composite decking
How it takes cleaning Makers publish their own cleaning limits, often including a maximum pressure.
What to watch for Look up the care guide for your brand before using a pressure washer or a strong cleaner.
Natural stone and flagstone
How it takes cleaning Soft or layered stone flakes under pressure and marks with acid cleaners.
What to watch for Brush and rinse first. Test anything stronger on one stone.
Real work
Steps and joints, cleaned.
Steps are where a slick surface matters most, and brick joints are where cleaning needs the lightest hand. This is one of Clear Summit’s own jobs.
The same walkway is shown before and after in one photo.

Read this before renting a machine
Pressure washers and cleaners.
The spray
The risk A pressure washer can cause serious wounds that at first look minor, and delay in treating them raises the risk of infection, disability or amputation (CDC (opens in a new tab)).
What to do Never point it at yourself or others. Wear closed, rubber-soled shoes and eye protection. Get medical attention quickly for any spray wound.
Electric shock
The risk The CDC also warns of electric shock if a pressure washer is not used properly and its safety instructions are not followed.
What to do Follow the manual. Keep cords and connections out of standing water.
Bleach
The risk Diluted household bleach removes mildew from a deck: the Forest Products Laboratory gives one part bleach to three parts water, rinsed off afterwards. It also harms the plants and lawn it runs onto.
What to do Never mix bleach with ammonia or with a detergent that contains it: the two form a toxic gas. The same goes for acids such as vinegar (Washington State Department of Health (opens in a new tab)).
Moss killers
The risk Products made for lawns often contain iron, which leaves rust-colored stains on concrete and stone.
What to do Use only a product whose label says it is for hard surfaces, and follow the label.
Where the water goes
The risk Many storm drains in Portland flow directly to a river or stream. The City allows only plain rinse water into the stormwater system: no soaps, detergents or chemicals (Environmental Services (opens in a new tab)).
What to do Sweep first. Divert wash water onto a planted or unpaved part of your property, and do not let it run into the street.
Know the limit
When to call.
A small concrete path is a fair job with a broom, a hose and patience. The case for calling grows with the area, the slope and how delicate the surface is.
- It is a wood deck. The wrong pressure furs and scars the boards for good.
- It is pavers or brick. The joints need care, and often re-sanding.
- The area is large. Driveways show every uneven pass.
- It is steep or stepped. Wet, soapy slopes are where people fall while cleaning.
- You have never used a pressure washer. A slick driveway is a poor place to learn.
- Run-off would reach a storm drain. The wash water has to go somewhere allowed.
The service
What Clear Summit’s pressure washing covers.
Clear Summit Cleaning offers pressure washing for the exterior surfaces around your home. Using specialized pressure washing tools and detergents, we clean the grime and algae from driveways, sidewalks, decks and fences.
When you request a quote, tell us which surfaces need attention and roughly how large they are, and we can discuss the right cleaning approach for each.
Siding is different. For the walls of the house we offer house washing, a gentler service. Read the pressure washing page.
What to tell the office
Which surfaces. Driveway, walk, steps, patio, deck or fence.
What they are made of. Concrete, pavers, brick, stone, wood or composite.
Roughly how large. A rough size is enough for a quote.
Where it is worst. Shaded sides, steps, or where a downspout empties.
Quotes are free, and a request is not a booking.
Prevention
Slowing regrowth.
In this climate a shaded surface will green up again. Treat it as upkeep, like mowing, and work on the damp and the shade in between.
- Sweep leaves and needles promptly. They hold water and feed the next growth.
- Let light and air in. Trim back the branches and shrubs that keep the surface shaded.
- Move the water. Send downspouts somewhere other than across a walk. See clogged downspout for where they should drain.
- Move the pots. Shift planters, mats and furniture now and then so the deck beneath can dry.
- Finish wood decks. A penetrating finish helps limit cracking, raised grain and mildew, according to the Forest Products Laboratory.
- Clean before it is thick. A light clean once growth appears is quicker and easier on the surface than a heavy one.
Questions people ask
Why is my deck or walkway so slippery when it rains?
A thin film of algae has grown on it. It is nearly invisible when dry and slick as soon as it is wet. Shade, damp and fallen leaves all encourage it.
Will pressure washing damage my concrete?
Concrete takes pressure washing better than any other surface around a house, but a nozzle held too close or too narrow can cut stripes into it and expose the stone. Wood, pavers and asphalt are damaged far more easily.
Can I pressure wash a wood deck?
With great care, or not at all. The USDA Forest Products Laboratory warns that power washing can remove wood from the surface, especially on softer wood such as western redcedar. A deck cleaner and a soft brush are safer.
Can I use bleach on a mossy driveway?
Diluted bleach kills algae and mildew, but it harms plants and lawn, must never be mixed with other cleaners, and in Portland must not run into the street or a storm drain. A stiff broom, water and a cleaner made for the surface is the safer start.
How do I keep moss from coming back between pavers?
Keep the joints filled with sand, sweep off leaves and soil, and let in as much sun and air as you can. In shade it will return and needs cleaning from time to time.
Does Clear Summit pressure wash decks and patios?
Clear Summit pressure washes exterior surfaces around the home, including driveways, sidewalks, decks and fences. Tell us which surfaces and roughly how large they are when you request a quote.
Sources
The safety and how-to points on this page come from these documents. Links checked November 17, 2026. What Clear Summit does on a visit is described from our own service pages.
- Pressure Washer Safety (opens in a new tab)Centers for Disease Control and Prevention. Pressure washer injuries, electric shock and what to do about a spray wound.
- Finishes for Wood Decks (opens in a new tab)USDA Forest Products Laboratory. What power washing and harsh cleaners do to deck boards, the bleach mix for mildew, and deck finishes.
- Dangers of Mixing Bleach with Cleaners (opens in a new tab)Washington State Department of Health. Why bleach must never be mixed with ammonia, acids or other cleaners.
- Non-stormwater Discharges from Residential Properties (opens in a new tab)City of Portland Environmental Services. What wash water may and may not go to the stormwater system.
Bring back the walkways.
Tell us which surfaces, what they are made of and roughly how large. Quotes are free.
